Trying to get at least a boot on the Installer but keep getting stuck.

System Specifications:

Dell Precision T3600
Xeon E5-1650
SanDisk SSD Plus 120GB (boot for Windows) Samsung 850 EVO 500GB ([potentially] macOS and other storage)
16GB [4*4GB] DDR3 ECC RAM @ 1600MHz
EVGA GTX 1050 Ti SC
A will to live

Setbacks thus far:

The computer only boots from USB if plugged into the USB port located inside the case and on the motherboard (shown is the install USB).
You cannot boot from EFI when using the above port for boot, so I have to use UniBeast's Legacy mode to boot to Clover via EFI.

Fix attempts so far:

Remove NullCPUPowerManagement.kext (this broke everything so I put it back)
Add USBInjectAll.kext (got a little bit of progress but I doubt it did anything)
UseKernelCache=No (didn't help at all)

How did I get here?

I followed the basic guide here[here](bit.ly/2z6Ocq2) to use UniBeast and High Sierra.
I created the USB with Legacy and Nvidia inject.

The Actual Issue

I keep getting stuck on the line that lists FakeSMC's version number. At this point, before the line even fully prints, everything halts. My USB will keep flashing for usage but after a while will just stop showing any signs of life. I took some pictures best I could with a phone camera, linked here and here

I've been stuck on this for a while and though I'm not optimistic it will run on a PC like mine, I have seen forum posts suggesting that my very same computer has successfully run a macOS of some sort. Thanks for all the help I can get.