I’ve been stuck at this for a while, I’ve followed so many setup guides, I made a USB installer via Unibeast (I didn’t check any of the graphics stuff since my hardware back at my desktop is GTX 1080) After that I put the multibeast folder on there, both of these on Mac. Then when I go to boot loader by using F12, I select it and it just black screens. Ok then, so now I try to install Clover on the USB drive using this method here. Nothing again. Just a black screen, I’ve been at this for hours and I don’t know what I’m doing wrong, I haven’t been able to load Mac on my PC even once. Secure boot is also off.
EDIT: also yes, my flash drive was properly formatted with GUID table and Mac (journaled). I’m attempting to install Catalina
[link] [comments]
Comments
Post a Comment