How to Fix How to recover deleted photos on my mac?? HELP During macOS Boot or Installation
Boot failures need a predictable pass through firmware, USB, storage, EFI and verbose logs before reinstalling macOS. Most installer stalls come from firmware settings, an invalid config.plist, wrong SSDTs, bad USB mapping or unsupported storage/controller settings.
Quick Checks
- Backup current state: Save a copy of your working EFI and run a full system backup before changing settings.
- Identify hardware components: Note down your exact CPU, GPU, Wi-Fi card, and motherboard/laptop model.
- Ensure utility alignment: Keep OpenCore, OCLP, and ProperTree updated.
Fix Steps
- Create a rollback point: Make a Time Machine backup and keep a copy of your last working EFI folder before editing OpenCore, kexts or root patches.
- Boot verbose: Add
-v keepsyms=1 debug=0x100so the final visible line gives a real clue. - Check firmware settings: Disable Secure Boot and Fast Boot, set SATA to AHCI, disable CFG Lock if possible, and use UEFI mode.
- Validate OpenCore: Update OpenCore, Lilu and core kexts, then run ocvalidate or ProperTree clean snapshot.
- Recreate the installer: Use a fresh USB installer and try another USB port; older Macs may need a USB 2.0 hub for input during setup.
- Reset NVRAM: Reset NVRAM from the OpenCore picker before retrying the installer.
Verify It Worked
- Verbose boot moves past the previous stopping line.
- The installer reaches Disk Utility and sees the target disk.
- Keyboard, mouse and USB remain active during recovery.
- OpenCore picker still loads after a cold boot.
Rollback
- Restore the last booting EFI folder.
- Use the officially supported macOS installer to recover the machine.
- Do not erase the internal disk until the installer can boot twice consistently.
Related iATKOS Searches
- OpenCore · OCLP · EFI · kexts · config.plist · macOS troubleshooting
Original Question: "How to recover deleted photos on my mac?? HELP!!!"
Thank you for the recommendations. I tried PhotoRec first, and it was a bit tricky to understand the ‘interface’ and recovery process, but I figured it out and managed to recover about 70% of the lost photos, and even some old photos from other shoots. After that, I scanned the card with Disk Drill, it was A LOT easier to use, lol. It found all the missing photos and was able to preview them. Now I’m thinking about buying the Pro version to recover everything… Thanks, everyone, for the advice and recommendations! Now my friend and I have all the funny guest photos again, the ones no other wedding photographer managed to capture 😅 The only downside is that, on top of my wedding gift, I now have to add the cost of macOS recovery software for deleted photos 😅
Author:
[source]
Post a Comment