Working on a new tower, fresh Mojave install via clover. Boots off the USB fine, and I can start the installer. However the installer stops a few seconds after starting, with verbose mode showing the following 3 lines for it's final output:
ERROR!!! Uncompress prelinked kernel
ERROR!!! Load prelinked kernel with status 0x800000000000007
Error loading kernel cache (0x7)
Build has the following hardware (which checks out as ok from a Win10 install on another drive on it)::
CPU i5-8600K 3.6GHz
Motherboard Gigabyte Z370 AORUS Gaming WIFI
Vidoe Card Radeon RX580
SSD Samsung 860 EVO 500GB
RAM Corsair, 4 sticks of 8GB each
I followed the bios settings from https://hackintosher.com/builds/gigabyte-z370-aorus-gaming-7-hackintosh-build-guide/
Using Clover_v2.4k_r4831 for the initial install. Pulled my config from https://hackintosh.gitbook.io/-r-hackintosh-vanilla-desktop-guide/ for Coffee Lake. SMBIOS set to iMac18,2. Loaded the lilu, Whatevergreen and FakeSMC. Made changes using the latest Clover Configurator.
I've tried the following to no resolution:
• -f UseKernelCache=No
• Made sure SIP was not enabled
• Checked and updated apfs.efi
• Swapped between OsxAptioFixDrv-64.efi, OsxAptioFix2Drv-64.efi, OsxLowMemFixDrv-64.efi, OsxAptioFix2Drv-free2000.efi, OsxAptioFix3Drv-64.efi and AptioMemoryFix-64.efi
• Rebuild the USB several times, meticulously following the instructions from several sites
• Built a High Sierra USB with the same result
• Tried EFI folders from other users with the same motherboard
Anyone have any suggestions for a resolution, or next steps in troubleshooting?
[link] [comments]
Comments
Post a Comment