How to Fix No port micro restart ( we don't support SMC on this platform) and then restart. SEE the attached photo

How to Fix No port micro restart ( we don't support SMC on this platform) and then restart. SEE the attached photo

Boot failures are caused by firmware settings, incorrect OpenCore configuration, or USB mapping problems.

Quick Fix Steps

1. Boot verbose: Add -v keepsyms=1 debug=0x100.
2. Check firmware: Disable Secure Boot, Fast Boot, CFG Lock; set SATA to AHCI.
3. Validate OpenCore: Run ocvalidate or ProperTree clean snapshot.
4. Recreate installer: Fresh USB drive, different port.

Verification

• Verbose boot passes the previous stop.
• Installer sees the target disk.

Related Searches

• OpenCore · EFI · kexts · config.plist · macOS troubleshooting

Original Question: "No port micro restart ( we don't support SMC on this platform) and then restart. SEE the attached photo."

When I click macOS installer after the second restart of the Big Sur installation, i get into this. So i can't finish installing Big Sur. Verbose shows no port micro restart ( we don't support SMC on this platform) , it immediately restarts after this part of the verbose. This image is a screenshot from the video i recorded as it immediately restart after showing this part of the verbose so i couldn't take a photo. https://preview.redd.it/thkmpxrtjw361.png?width=2208&format=png&auto=webp&s=86c4458e7a4291867273f35bb4e33b275b78851d submitted by /u/bemyking [link] [comments]